Lane BERT Signal
Signal (Page 1-2)
The Signal tab (fiber ports only) displays the receiving (RX) and transmitting (TX) optical level measured by the QSFP28, QSFP-DD, QSFP+ or OSFP transceiver.
Loss of Signal (LOS) and the Saturation level for the optical signals are shown graphically including the level measurement in dBm for each lane.
Signal (Page 1)
Signal (Page 2)
Signal (Page 3)
The received signal frequency and offset is measured and preformed on the optical interface.
-
Current: Indicates the frequency of the input signal.
-
Offset: Indicates the difference between the standard rate and the rate of the input signal.
-
Min (ppm): Indicates the difference between the standard rate and the minimum deviation detected in the input signal.
-
Max (ppm): Indicates the difference between the standard rate and the maximum deviation detected in the input signal.
Signal (Page 3)
Signal (Page 4-5)
Page 4-5 displays the Optical module information and status.
Signal (Page 4)
Signal (Page 5)